What Is T40 Rattler And How To Use It

by

Introduction Of T40 Rattler

The T40 Rattler is the personal H2S monitor. It is used for the detection of H2S gas in oil and gas production units.

T40 Rattler

The T40 Rattler is a personal gas detector that helps detect the presence of harmful hydrogen sulfide gas in the air. It’s commonly used by workers in industries like oil and gas where exposure to this gas can be a risk.

This gas detector is small, portable, and can be worn on a belt or attached to clothing using a clip. It has a solid-state sensor that detects H2S gas and provides visual and audible alerts when gas concentrations exceed safe limits. The T40 Rattler is user-friendly, with simple one-button operation and easy sensor replacement.

How To Use T40 Monitor

  1. Read the user manual: Before using the T40 Rattler, it is important to read the user manual carefully to understand its features and how to operate it correctly.
  2. Turn on the device: Press and hold the power button until the display shows the start-up screen.
  3. Perform a fresh air zero calibration: To ensure accurate readings, the T40 Rattler should be calibrated to the ambient air. To perform a fresh air zero calibration, press and hold the calibration button until the device prompts you to begin calibration. Follow the on-screen instructions to complete the calibration process.
  4. Wear the device: The T40 Rattler should be worn in a location that provides a representative sample of the air being breathed. This typically means wearing it in the breathing zone, near the mouth or nose.
  5. Check for gas: The T40 Rattler continuously monitors the air for H2S gas. If gas is detected, the device will sound an alarm and display the gas concentration on the screen.
  6. Respond to alarms: If an alarm sounds, move away from the source of the gas, and take appropriate action based on your organization’s procedures for dealing with gas hazards.
  7. Turn off the device: When you are finished using the T40 Rattler, turn it off by pressing and holding the power button until the screen goes blank.

FAQ

What is the cost of T40 rattler?

Cost of T40 rattler varies between 150 USD to 200 USD.

How to calibrate T40 rattler?

You will need to expose the detector to a known concentration of H2S gas, and then adjust the settings until it produces a correct reading.

Leave a Comment